WRDP Evaporators

Waste Recovery Designed Products, Inc.
Industrial Evaporators

Water/Oil Separators

Features

Zero parts per million of oil down the drain from your compressed air system condensate. Nothing goes down the drain! The centuries old system of distillation removes water as steam vapor with no EPA permitting required. Every few months concentrated oil is drained and placed in a hazardous waste container for professional removal.

Water/Oil condensate from your compressed air system, air aftercoolers, air dryers, and air receivers are loaded into the Water/Oil Separator's fill connection. The Separator automatically turns on when the condensate reaches a high level predetermined by the electronic high level probe, and turns off at a predetermined low level by the low-level probe. This always assures that the heating element is immersed in the condensate. If the Water/Oil Separator has more condensate capacity than you need, it will only consume power as needed. The unit has no moving parts or filters to be replaced! It is maintenance free! Our process will also separate water from synthetic oil including polyglycol/ester. The boiling point of water is significantly beneath the flash points of regular or synthetic compressor oils. There are no detrimental VOC emission, only the concentration of warm oil.

For single or multiple compressed air systems, the condensate is gathered in a 55 gallon plastic drum or larger non-metal type container. The Water/Oil Separator is supplied with a submergible pump and hose kit which is placed into the plastic drum. The pump will be automatically turned on and off by the high and low level probes in the Water/Oil Separator as varying distillation levels require.

Model	Voltage	Amps*	Capacity	Heater	Output	Length	Width	Height
EV200	240VAC, 3PH	25 A	10 GAL	6 KW	2.5 GAL/HR	23 in	25 in	31 in
EV200/2	240VAC, 3PH	50 A	25 GAL	12 KW	5 GAL/HR	27 in	29 in	37 in
EV200/3	240VAC, 3PH	75 A	38 GAL	18 KW	7.5 GAL/HR	30 in	32 in	38 in
EV200/4	240VAC, 3PH	100 A	50 GAL	24 KW	10 GAL/HR	33 in	35 in	41 in
EV400	480VAC, 3PH	13 A	10 GAL	6 KW	2.5 GAL/HR	23 in	25 in	31 in
EV400/2	480VAC, 3PH	25 A	25 GAL	12 KW	5 GAL/HR	27 in	29 in	37 in
EV400/3	480VAC, 3PH	37 A	38 GAL	18 KW	7.5 GAL/HR	30 in	32 in	38 in
EV400/4	480VAC, 3PH	50 A	50 GAL	24 KW	10 GAL/HR	33 in	35 in	41 in
EV400/6	480VAC, 3PH	75A	75 GAL	36 KW	15 GAL/HR	48 in	35 in	41 in

* For installation and wire gauging only!

Other Features and Benefits:

Electrical Components
All electrical components are UL Rated and/or listed. Meets latest codes.
Over Temperature Shut Off
Condensate boiling temperature is kept between 215 to 230 degrees F which prevents detrimental VOC emissions.
Condensate
Condensate automatic feed circuit is standard on all units, a completely turn-key system.
Boiling Tank
Boiling tank is constructed from 304 stainless steel for longer life
Condensate Pump
Condensate pump load is rated at 120 VAC, 10 Amps max.
Disconnect Switch
On models EV200/3, EV400/3, EV200/4, EV400/4, and EV400/6 main power disconnect switches are supplied with units. Disconnect switches are part of the control panel assembly.

For more information, e-mail us at wrdp@usaor.net , or call 724-926-5110
Check out our new filter.

Back to WRDP Homepage